germatwo.blogg.se - Sheetcam post processor

#Sheetcam post processor install
#Sheetcam post processor update
#Sheetcam post processor code

You may need to drag on the window to the right to widen it. In SheetCam click on "Menu ->Tools -> Cutting Rules". Otherwise you may delete them (repeatedly) by pressing Control-Z in a higher level window. You don't need to save your changes to the current file, but you do need to save the default tool set when prompted, so click Yes for the default tool set save prompt so these values are saved.

#Sheetcam post processor code

The Code Snippets should now appear in your Tools Window. The asterisks and pluses were added to the comment lines above to make it easier to see them in the GCode. Make sure that you are using Output#4 for AD2, otherwise edit the Tool Code so that the outputs match your P#.

Click on "Menu ->Tools -> Code" Add the two following Code snippets - but don't include the quotes:Ĭode Name: "THC Inhibited via AD2" Actual Code Snippet: "M63P4 (***THC Inhibited, AD2***)"Ĭode Name: "THC Allowed via AD2" Actual Code Snippet: "M62P4 (+++THC Allowed, AD2+++)" This will also provide the rules for THC Inhibited and THC Allowed This will provide you with two code tools (shown in step 3b) that you will need for the rules in the next step to work. Open SheetCam and click on "Menu ->File -> Open Job Template" and select this file. Download the file ( you may need to right click on the link and click "Save link as"). If you DON'T have a tool table, here is a Default TMC3in1 v003.jobt template file to use. Only do step 3a or do both steps 3b and 3c.

#Sheetcam post processor update

This step is required for the post processor to update SheetCam correctly. P3 is for Output#3, P27 is for Output#27, etc. While still in the "Post Processor" tab, click on "Edit Post", Find the two lines:Ĭhange the P3 to match the output number you have selected for your torch relay.

TMC3in1 Mach4 v002.scpost Version 002 added GCode comments to make it easier to see where the Torch is turning on and off, along with when a Probe/Reference is happening (as shown in 2b below).

This has been modified so that you specify the "Pierce Drop to Fire Torch" which will bring you down to pierce height.

TMC3in1 Mach4 v003.scpost Version 003.

This changed a G04 P0.001 delay to P0.0011 so that it would not be skipped by Mach4 as being to short of a delay (a single millisecond).

TMC3in1 Mach4 v004.scpost Version 004.

Open SheetCam, then go to "Menu -> Options -> Machine"Ĭlick on the "Post Processor" tab, and then at the bottom click on "Import Post", select this file (after you have downloaded to your machine - you may need to right click on the link and click "Save link as") It takes about 90 seconds to recreate the rules from the screen shots below if you choose to go with the Stable branch.Ģ. Either Development or Stable will work, but only Development will allow you to import the rules.

#Sheetcam post processor install

SheetCam Setup and Usage Guide for the TMC3in1 in Mach4 with the ESSĭownload and install SheetCam TNG Stable or Development from here.